Cookie-Einstellungen
Diese Website benutzt Cookies, die für den technischen Betrieb der Website erforderlich sind und stets gesetzt werden. Andere Cookies, die den Komfort bei Benutzung dieser Website erhöhen, der Direktwerbung dienen oder die Interaktion mit anderen Websites und sozialen Netzwerken vereinfachen sollen, werden nur mit Ihrer Zustimmung gesetzt.
- Artikel-Nr.: 198277870
- Hersteller-Nr.: RDRP0452-2mm
- Bis 16 Uhr bestellt, Morgen Geliefert!
- 30 Jahre RC Modellbau Erfahrung
- Top Service von Profi Modellbauer
- Über 500 Hersteller - 200`000 Artikel
RDRP0452-2mm Revolution Design EB410 Carbon Fiber Shock Tower Rear -2mm The Revolution... mehr
Produktinformationen "RDRP0452-2mm EB410 Carbon Shock Tower Rear -2mm"
RDRP0452-2mm Revolution Design EB410 Carbon Fiber Shock Tower Rear -2mm
The Revolution Design Racing Products Carbon Fibre Shock Tower for the Tekno EB410 1/10th 4WD buggy does away with the somewhat bulky and unsightly standard plastic part. While improving the overall looks of the buggy the lightweight carbon fibre part will also save a good amount of weight, which results in a lower centre of gravity and thus less body roll during cornering and hence higher overall speeds. The rear “-2mm” specification shock tower is used in combination with the gearbox riser shims, it corrects the suspension geometry and droop settings, and it is machined from high-quality 4mm glossy finish carbon fibre.
A direct fit on the EB410 buggy when using rear gearbox raiser plates.
The Revolution Design Racing Products Carbon Fibre Shock Tower for the Tekno EB410 1/10th 4WD buggy does away with the somewhat bulky and unsightly standard plastic part. While improving the overall looks of the buggy the lightweight carbon fibre part will also save a good amount of weight, which results in a lower centre of gravity and thus less body roll during cornering and hence higher overall speeds. The rear “-2mm” specification shock tower is used in combination with the gearbox riser shims, it corrects the suspension geometry and droop settings, and it is machined from high-quality 4mm glossy finish carbon fibre.
A direct fit on the EB410 buggy when using rear gearbox raiser plates.
Kundenbewertungen für "RDRP0452-2mm EB410 Carbon Shock Tower Rear -2mm"
Bewertung schreiben
Weiterführende Links zu "RDRP0452-2mm EB410 Carbon Shock Tower Rear -2mm"