RC4WD 1/14 4X4 Overland Hydraulic RTR Truck

VVJD00065 1/14 4X4 Overland Hydraulic RTR Truck w/Utility Bed

Specifications:
Hard Plastic European Style Front Cab
Full Metal 2 Speed Transmission (Planetary Gears)
Transfer Case (Billet Aluminum)
Scale Fuel Tank (Billet Aluminum)
Super Scaled Leaf Spring Suspension Setup
Scale Rims (Billet Aluminum)
Remote Lockable Front and Rear Axles (Locking Differential)
Full Metal Front and Rear Axle Housing
Steel Scale Drive Shaft
Realistic Front Cab Latch
LiPo Cutoff
Molded Functional Fuel Tank
Rear Light Guards
Scale Light Buckets (Fits 3-5mm LED)
Recommended Payload: 10kg / 22lbs
Painted Body
Scale Wheels and Tires
Brushed Motor
Maximum Lift Power: 42kg / 92lbs
930KV Brushless Motor-Driven Micro Hydraulic Pump
Spare Tire Included
Automatic Trailer Gate (Do Not Attempt to Open by Hand)
Length: 25.1in / 638mm
Width: 9.05in / 230mm
Height: 10.7in / 273mm (Including Antenna)
Weight: 6.8kg / 14.9lbs
Axle Gear Ratio: 2.6 : 1
Maximum Load: 15kg / 33lbs
First Gear 1:64, Second Gear 1:16 (Transmission)
Basic 6 Channel 2.4Ghz Radio

What's Included:
1x 1/14 4X4 Overland Hydraulic RTR Truck w/Utility Bed

Required Parts:

5000mAh 11.1V 50C 3S1P LiPo Battery Pack with XT60 Plug (Battery size must be no bigger than 140mm in length, 45mm in width, and 25mm in height)

Compatible Battery Charger
4x AA Batteries for Radio (Z-S1718)
Chevron AW ISO 32 Hydraulic Oil 14oz (Z-X0042)

Notes:
When raising the dump bed, do not leave at upper-most position for more than 2 seconds, doing so may cause damage to the hydraulic system.
Do not push/pull the truck by the tailgate, doing so may cause damage to the locking mechanism.
Do not use more than 3S battery. (11.1 volt(s))
Do not try to operate lift past its fully-extended height, doing so may cause damage to hydraulic system.
Must turn on the transmitter before starting the ESC.
ESC Supports XT60 Connector

While some components may come assembled, we recommend checking the hardware and screws are all properly secure, especially after shipping. As an option, you may want to apply thread lock to some of the installed hardware.
Use good quality hex drivers to avoid stripping screw heads.
Use thread lock when putting metal screws into metal parts.
Steps marked with an asterisk (*) require threadlock.
Use threadlock sparingly.
Do not over tighten screws, or you may strip the thread.
This product is for experienced R/C users. Not recommended for beginners.
The axle hubs can be removed, but may require additional force.
This Product Is Professionally Pre-assembled
Manufactured by JDCustoms 30 Days Limited Warranty