Align T-REX 450LP Dominator ARTF (AC) 3S Baukasten Kit

Align T-REX 450LP Dominator ARTF (AC) 3S Baukasten Kit Technische Daten: - Länge: 705mm - Höhe: 205mm - Breite: 110mm - Hauptrotordurchmesser: 734mm - Heckrotordurchmesser: 171mm - Motor Ritzel: 11 Zähne - Antriebszahnrad: 121 Zähne - Autorotationszahnrad: 106 Zähne - Heckrotorzahnrad: 26 Zähne - Getriebeübersetzungen: 11:1:4.07 - Gewicht ohne Akku: ca 730g Inhalt: 1x T-REX 450LP 3S / ARTF (almost ready to fly) 1x MINIGRS Flybarless System 1x A10 Transmitter 1x A6B Receiver 1x RCE-BL45P 45A Brushless ESC 1x 460MX Brushless Motor (3200KV) 3x DS450 Digital Servo 1x DS455 Digital Servo 1x Paar 325 Carbon Fiber Blades 1x LiPo Akku 2200mAh/30C - 3S1P - 11.1V (Weight: 165g) 1x Balancer Charger RCC-3SX 4x Battery AA 1.5V Wird noch benötigt: - Pitch Messgerät A10 Transmitter Specification: - Channel: 10-Channel - Available Models: helicopter/airplane/multicopter - Frequency range: 2.4055 ~ 2.475 GHz - Power: no higher than 20dBm - System Mode: 2.4G system AFHDS 2A - Suitable Voltage Range: 4.0 ~ 6.0V DC - Receiving Distance: the open ground no interference < 1000M - Low Voltate Warning: Lower than 4.2V - Weight: 487g (excluded battery) - Size: 187x89.6x215mm MINIGRS FBL Specification: - Operating voltage range: DC 3.5~8.4V - Operating current consumption: <100mA @ 4.8V - Rotational detection rate: ±300°/sec - Rudder yaw detection rate: ±600°/sec - Sensor resolution: 12 BIT - Swashplate Support: 120° CCPM Swashplate - Mode Support: T-REX250, T-REX450, T-REX470, T-REX500 - Receiver Support: ALIGN A10(A.BUS), Futaba S-FHSS, DSM2/DSMX - Operating temperature: -20? ~ 65? - Operating humidity: 0% ~ 95% - Comply with RoHS - Size: 37.6x22.4x13mm Balance Charger RCC-3SX Specification: - Input Voltage: AC 100V~240V(50/60Hz) - Output Voltage: 2cell DC 7.4V / 3cell DC 11.1V - Supported Battery Type: Li-polymer / Li-ion - Charging Method: CC/CV - Charging Current: 2A - Size: 123x74.3x32mm - Weight: 260g LiPo-Akku Specification: - Output: 11.1V 2200mAh 24.4Wh(3S1P) - Supports 5C charging - Dimension: 104x36x22mm - Weight: 165g - 14AWG heat-resistant silicone rubber wire. Heat resistance: 200 ° C / Current withstand: 50A